Where to Work?

Where to Work?

I knew I was going to be working on this camper for a while and we needed a place to park it and work on it.
First we thought that behind the house would work out well.  We have a tent that we thought would cover the camper and work area.  We set up the tent out back and Brian hooked up the camper to the ATV.






As you might notice the camper was a bit too tall for the tent.  So plan "A" was out the window.  I helped to take the tent down and then went golfing!

When I got home I found the camper....


in the pole barn!

Yes the husband put it there!  All his friends are telling him that I will take over his shop.  We will have to wait and see.



Comments

Post a Comment

Popular posts from this blog

So I Bought A Travel Trailer

Image
Yep I bought a 1977 Maple Leaf Travel Trailer! A few months ago I mentioned to my husband that it would be fun to renovate a travel trailer.  You see people on line do it and they look so cute.  It would be so much easier to flip than a whole house.  For some reason my husband told his co-workers about it and low and behold one of his co-workers had a travel trailer to he wanted to sell.  We decided to go check it out the following Saturday.  It was about an hour twenty minute ride.  Here is what we saw: You guessed it - it's a 1977 Maple Leaf Travel Trailer an obscure manufacturer out of Indiana only made for a few years in the seventies.  More about that later. It has sat in this yard for 20 years and used as a bunk house.  There is water damage and smells kind of funky.  But good luck finding one that doesn't! We took a few days and decided to go for it.  My plan is to update this blog every couple of weeks or so to share my progre
Read more

Corner Molding

Image
Corner Trim Now that we have a place to work it's time to really get started.  We know there is lots of water damage and rot going on so the best thing for us to do is to completely dismantle  Lettie down to the trailer.  We wanted to get the exterior skin off first.   We started removing screws from all the corner molding that was holding the skin together at the corners. Yes more screws and more Butyle tape! From the start I knew the back passenger corner had issues.  It was caked with silicone and there were even a couple of heavy duty nails holding the trim in place.   We were able to pry a couple of those nails out with a hammer.  But the last two or three we had to give in and cut the nails. Once the trim was off we got a glimpse of what was waiting for us under the skin.  In a couple of spots we could get a screwdriver in the seam and it just went right in - there was nothing in there to stop it! Back driver side top corner (Tally the Y
Read more